Searched around here looking for some info on mounting an SUV body to Z2 chassis (Proline K5 blazer) and didn't come up with much. Any suggestions or products I should check out? Z2 has lots of articulation after installing my new lower links and wheel widners so Id like to have plenty of space between the body.

RPM makes em' for the e-maxx, perhaps they can be adapted?
Also might want to look at the mounts for the summit.

Or you could do the mounts out the side. CPE sells those.

Found Parma makes universal mounts in 3.5" and 6" lengths. Looks like I'm hittin up the LHS tomorrow... If my head doesn't look like a pumpkin (had all 4 wisdom teeth taken out today ).

Ouch! Been there, mine were mesed up and had to come out in pieces (oral surgery).
I hope that's not what you went through.

Luckily Mine were not difficult to take out (all 4 of 'em). I shelled out for full sedation so I didn't feel a thing. So far it's been a breeze. Not too swollen today either. Everyone I talked to about them had nothing but horror stories though. Sure nice to have them gone and done.

Ordered a set of mounts from CPE today as well as some other goodies. Can't wait to order a chassis from them...