Talk about materials, fabrication, fasteners, soldering, and anything else here.
5 posts • Page 1 of 1
- Approved Member
- Posts: 470
- Joined: Sat Jan 01, 2011 9:10 pm
- Location: Great White North (Ontario,Canada)
I am doing a set now, I started with a new OLFA knife blade cut off as much as possible then touched up with a die grinder. I have 2 done and the other 2 need a grind and finishing
- Regular Member
- Posts: 28
- Joined: Thu Oct 08, 2015 3:23 pm
- Location: Repentigny, Québec, Canada
This type of sander is excellent too!!! I'm not a big fan of shaving but the previous owner of my tires had already started and since it was badly done, i had to finish the job to have them look good! LOL Also, mineral spirits helps too, as it ''melts'' rubber, in a certain way!
Users browsing this forum: No registered users and 1 guest