Tube frame

Talk about materials, fabrication, fasteners, soldering, and anything else here.
User avatar
Approved Member
Posts: 5613
Joined: Thu Jan 01, 2009 4:13 am
Location: Oregon city, Oregon

Re: Tube frame

Post by vwjuice » Sun Jan 10, 2010 5:26 am

Go with the 55t. 75 will be really slow.
SFC K is my hero!
All bow down before the great terminator-smilie!

User avatar
Approved Member
Posts: 1129
Joined: Sat Nov 27, 2004 12:59 am

Re: Tube frame

Post by NOUSEFORANAME » Sun Jan 10, 2010 4:26 pm

lipbr302 wrote:Can you just use a portable torch to braze like you would find at the hardware store?
Yes, but use actuall brazing fuel, propylene etc, not those small butane torches.

User avatar
Posts: 13991
Joined: Tue Feb 17, 2004 6:03 am

Re: Tube frame

Post by Halgar » Sun Jan 10, 2010 5:08 pm

The twin bottle hobby torch you'll find at Evil Orange and other box stores will work fine, you will go through some fuel though. There is a review here on it. From this info, specialty gas isn't necessary because you're mixing oxygen with the mapp gas which significantly increases heat output.
I used to think I was indecisive, but now I'm not so sure.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest