I had a DX6i for some time now and I've been wanting to use it for a crawler application. But like a lot of people, I want the left stick to self center and I was finding it difficult to source the parts to do so.
After opening the case and starring at it for a while the idea hit me. A few return springs and some servo screws and this just might work...and it did! The end result works just like the right side but is a little stiffer and makes a small amount of noise from the springs I used but doesn't interfere with any other radio functions.
I'm sure this simple solution has been done before but I didn't see it anywhere so I figured I'd share my experience.
Have a look.
Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Talk about radio's, servo's, lighting, and anything else run though a receiver or radio here.
1 post • Page 1 of 1
Users browsing this forum: No registered users and 1 guest