DX4R pro and dual sidewinder ESCs

Talk about radio's, servo's, lighting, and anything else run though a reciever or radio here.
Post Reply
rknaub
Approved Member
Posts: 131
Joined: Thu Jul 17, 2014 2:51 am

DX4R pro and dual sidewinder ESCs

Post by rknaub » Tue Nov 04, 2014 8:36 pm

Dx4r pro, two sidewinder 3s, sr410 rx, CC BEC, clodbuster.

Y cable to the throttle channel won't work, both ESCs beep as if no rx detected. I have calibrated both endpoints independently plugged into throttle ch.

With one on thr ch, and one on aux2, I can get them both to work in MOA mixing, but have to go into the mix menu every time i power the truck back on, otherwise only the thr ch ESC arms, and the aux2 one doesn't... Just blinks red.

Generic dual thr mixing I can't get to work at all... Which is what I really prefer... Don't need dig on this truck.

Dx4r has latest firmware, as do both sidewinders. Red wire removed from both ESCs because of the BEC.

Any suggestions?
My flagship 6x6x6 build: viewtopic.php?f=50&t=29626
Peterbuilt crawler build "HellFire": viewtopic.php?f=46&t=29618
Basher build: viewtopic.php?f=46&t=29750

Post Reply
Users browsing this forum: No registered users and 2 guests