Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Discuss all the facets of R/C electronics here.
7 posts • Page 1 of 1
Hi everyone. First im new to this site and love it. Ok i have heard and seen ppl using 3s lipos with xl5 esc. And i know ppl have ran 4s on the stock 27 turn motors. And i know esc specs. says 9.6 volts max. Just wanted ppls opinion on if its safe or wise to run 2 xl5 escs with two stock 27 turn motors on 2 3s lipos?
You only need one XL-5 to run a a pair of 27t motors... the 3S part is a gamble. If you don't care if the esc fries, I would try it, just to see what happens. Otherwise, I would just use a different esc.
Don't want to thread hijack but I plan to run my xl5 with 2 silver cans, how does one go about wiring both motors?
You need extra wire and connectors to make a Y-harness at each motor lead.
So basically split the single wires into duals and hook them to their respective motors?
Yes, one set of +/- to each motor, and hook the one's to the rear motor up opposite, so that is runs backwards (the rear motor needs to run backwards).
Thank you sir!
Users browsing this forum: No registered users and 3 guests