y harness for motors?

Discuss all the facets of R/C electronics here.
Post Reply
haganator
Approved Member
Posts: 657
Joined: Sun Jun 27, 2004 2:34 am
Location: charlestown indiana

y harness for motors?

Post by haganator » Thu Mar 03, 2005 9:13 pm

how could i make one. i did a search but couldnt find anything. if somone could sho a pic of theirs that would be great.
this IS the greatest sig in the world, not just some lousy tribute.

User avatar
Big Schott
Regular Member
Posts: 107
Joined: Tue Mar 09, 2004 9:25 pm
Location: Chokio, MN

Post by Big Schott » Thu Mar 03, 2005 9:24 pm

Are you trying to wire in Par. or in Ser.??

haganator
Approved Member
Posts: 657
Joined: Sun Jun 27, 2004 2:34 am
Location: charlestown indiana

Post by haganator » Thu Mar 03, 2005 9:27 pm

parellel(i know i spelled that wrong) and i have seen the wiring charts. i just need to know how to make the harnesses.
this IS the greatest sig in the world, not just some lousy tribute.

User avatar
Big Schott
Regular Member
Posts: 107
Joined: Tue Mar 09, 2004 9:25 pm
Location: Chokio, MN

Post by Big Schott » Fri Mar 04, 2005 9:44 pm

That's why I just put Par. (I suck at spelling).


OK What I do is...
Solder the wires to the motors front and back.

At about 3" from the rear motor cut 1/4" of insulation off the wires.

get solder on the these 1/4" bare wires.

put solder on the ESC wires .

Then solder the ESC wires to the 1/4" openings.

I like to solder the ESC wires to the motor wires so that the wires are side by side. Then you can slide on some "Heat shrink" and make it look "Nice".

I will try to get some pictures next week if I can.

stampede_dude
Regular Member
Posts: 359
Joined: Fri Feb 20, 2004 10:29 pm

Post by stampede_dude » Sun May 08, 2005 8:44 pm

2 threads down

viewtopic.php?t=165

jerb_dervis

Post by jerb_dervis » Wed Jan 18, 2006 5:25 pm


Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests