Need advice on new cvd/xvd

Talk about the Clod Buster, and all other motor on axle trucks here.
Want to see your truck featured on the home page? Enter our monthly contest in the general discussion section!
Forum rules
Want to see your truck featured on the home page? Enter our monthly contest in the general discussion section!
Post Reply
User avatar
hivemind
Approved Member
Posts: 68
Joined: Sat Nov 22, 2014 1:34 am

Need advice on new cvd/xvd

Post by hivemind » Wed Apr 19, 2017 6:39 pm

Hey guys, I need some advice. Today I busted the ancient cvd's on the front of my Lady. I have JPS tubes, gearcases, and knuckles. I was looking at TTR and RC4WD replacements. I did a little homework and want to know if anybody has experience with both brands. I bought a set of the Duratrax hatchet wheels for it as I figure it's about time for version 9.0 on the old Clod. Just need to know if they will fit the JPS knuckles. I saw a couple posts here saying the 4mm bearings are a bit too wide and am a little trigger shy now until I find out if they will fit. Thanks for your comments.

Post Reply
Users browsing this forum: No registered users and 9 guests