Velcro mount kit

Support forum for CPE.
http://www.teamcpe.com/

Moderator: cpe mt

Post Reply
rknaub
Approved Member
Posts: 141
Joined: Thu Jul 17, 2014 2:51 am

Velcro mount kit

Post by rknaub » Tue Nov 18, 2014 4:09 am

Ok so I got my mount kit today for my CF terminator chassis... but the threaded posts wont screw onto the screws that are meant for the body mounts. What am I missing? I took the plastic mounts off thinking the aluminum posts will thread on, and they do not.. looks like they might be tapped differently on each side, neither side fits.
My flagship 6x6x6 build: viewtopic.php?f=50&t=29626
Peterbuilt crawler build "HellFire": viewtopic.php?f=46&t=29618
Basher build: viewtopic.php?f=46&t=29750

User avatar
cpe mt
Approved Member
Posts: 1185
Joined: Thu Dec 01, 2005 2:14 am
Location: Upstate NY
Contact:

Re: Velcro mount kit

Post by cpe mt » Tue Nov 18, 2014 5:04 pm

One end is tapped for the #8-32 stud on the chassis (where the body mount had been), and the other is tapped for the #6-32 hardware included with the kit.
Brett Crawford - Owner
Crawford Performance Engineering
http://www.teamcpe.com

rknaub
Approved Member
Posts: 141
Joined: Thu Jul 17, 2014 2:51 am

Re: Velcro mount kit

Post by rknaub » Tue Nov 18, 2014 11:24 pm

cpe mt wrote:One end is tapped for the #8-32 stud on the chassis (where the body mount had been), and the other is tapped for the #6-32 hardware included with the kit.

I guess I can get an 8-32 tap and try to retap the threads then. All 4 of the studs will not screw onto the posts in the chassis.

It is obvious which side is supposed to be the 8-32 side, they just won't thread on.
My flagship 6x6x6 build: viewtopic.php?f=50&t=29626
Peterbuilt crawler build "HellFire": viewtopic.php?f=46&t=29618
Basher build: viewtopic.php?f=46&t=29750

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest